Yamaha Amp Editor Uživatelský manuál stáhnout pdf (Strana 21)

Chapter 3 Setup

Amp Editor Owner’s Manual

7. Use an Ethernet cable to connect the [NETWORK] connector of the XMV to a network

switch, and then power-on all devices.

8. Verify that all connected devices are shown in the Tree View window.

• Make sure that all devices are displayed in the Tree View, then click the [Manual Mode] button.

In this way, the IP address assigned to the devices by the Auto IP Address Assignment function

will become static. This is a convenient way to assign a static IP address, especially if you want

to facilitate assignment of the IP address when the system starts up, or if you want to control

the devices using a remote controller, such as AMX/Crestron.

• Once the device IP address becomes static, uncheck the [Enable] checkbox in the Auto IP

Address Assignment section (page 92).

• It may take some time for IP addresses to be assigned to the devices. Correspondingly more

time will be required for a larger number of devices.

• If the network settings of a device are not the factory settings, it might not appear in the Tree

View window. In this case, operate the device’s front panel to change the IP Address Mode to

[DHCP], or initialize the device’s memory.

On the TXn unit, use [Utility]  [Network Setup] to change the IP Address Mode to [DHCP],

and then press the unit’s front panel [ENTER] button.

On the ACD1 unit, use [6.Network Setup]  [IP Address Mode] to change the IP Address

Mode to [DHCP]. For details on initializing the memory, refer to the owner’s manual or refer-

ence manual for each device.

NOTE

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 210 211

Žádné komentáře

Yamaha Amp Editor Uživatelský manuál Strana 21