Yamaha Amp Editor Uživatelský manuál stáhnout pdf (Strana 15)

Amp Editor Owner’s Manual

Chapter

Setup

To use Amp Editor to monitor and control your equipment, you must first specify the IP address for your

computer and devices, and the ID for your devices.

• A Device ID is a unique number assigned to each device to be recognized by the network. Depending on the

product, the Device ID might be represented differently. For example, on the TXn or ACD1, it is called “Device

ID” and expressed in decimal numbers. On the XMV, it is called “UNIT ID” and expressed in hexadecimal num-

bers. In this manual, the term Device ID or UNIT ID will be used depending on the product.

Device ID settings

Here’s how to set the Device ID so that Amp Editor can distinguish each unit. If multiple devices exist on the

same network, you must assign a unique ID to each device.

 For the TXn

Power-on the TXn.

After approximately ten seconds, the unit’s front panel display will show the HOME screen.

2. On the front panel of the unit, hold down the [ENTER] button for one second or longer.

The Device ID setting screen will appear.

3. Use encoder B on the front panel of the unit to select the Device ID. You can select a

value in the range of 0–255.

If multiple ACD1 and/or TXn units are connected to a single network, set each unit to a different Device

ID.

4. On the unit’s front panel, press the [ENTER] button.

The value you specified will be applied to the unit.

• The value you edit will blink until you press the [ENTER] button. If you move to a different

screen while the value is still blinking, the change you made will not be applied.

5. Repeat steps 1–4 to specify the Device ID for each connected TXn unit.

• You can also change the Device ID on Amp Editor’s [Change Device ID] dialog box (page 108)

after the devices are synchronized with Amp Editor.

NOTE

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 210 211

Žádné komentáře

Yamaha Amp Editor Uživatelský manuál Strana 15