Yamaha Amp Editor Uživatelský manuál stáhnout pdf (Strana 129)

Chapter 8 Device Properties window

Amp Editor Owner’s Manual

129

 [General] tab (XMV)

Here you can specify input signals and channel frequencies. You can change these settings only when online.

q INPUT SOURCE

This setting enables you to select either Analog or Digital as the input source.

• If Digital is selected, digital audio will be input via YDIF on the XMV4140, XMV4280, XMV8140, or

XMV8280. On the XMV4140-D, XMV4280-D, XMV8140-D, or XMV8280-D, analog audio will be

input via Dante.

w OUTPUT SETUP

This section displays the [SPEAKERS] DIP switch settings on the XMV’s rear panel.

• The indicator “---” will appear instead if the unit is offline or if the [SPEAKERS] DIP switches have

been set to something other than the specified combination. For more information on the [SPEAK-

ERS] DIP switches, refer to the XMV Owner’s Manual.

e HPF

This section enables you to specify the HPF frequencies. You can select 40Hz/80Hz for high impedance, and

OFF, 40Hz or 80Hz for low impedance.

• The indicator “---” will appear instead if the unit is offline or if the [SPEAKERS] DIP switches have

been set to something other than the specified combination.

NOTE

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 210 211

Žádné komentáře

Yamaha Amp Editor Uživatelský manuál Strana 129