Yamaha Amp Editor Uživatelský manuál stáhnout pdf (Strana 187)

Chapter 11 Custom control panels

Amp Editor Owner’s Manual

187

Editing controls

The controls you copied can be edited in the custom control panel.

 Selecting a control

The way in which to select a control is the same as in the component editor or Detail View window. Click to

select a control, or <Shift> + click to select multiple controls. You can clear a selection by holding down the

<Shift> key and clicking the selected control. If you begin dragging from a location in a window where no

controller is displayed, a border will appear, and the controls within that border will be selected. A red border

is shown around the selected control(s).

 Moving

You can move the selected control(s) by dragging them or by using the keyboard’s cursor keys. If you’ve

shift-clicked to select multiple controls, those controls will move together.

 Dragging

If the grid is on, the upper left of the control(s) you drag will snap to the grid. The coordinates of the upper

left corner of the control are shown while you’re dragging it. The distances to the right and downward are

shown in units of pixels, relative to the upper left corner of the window.

 Cursor keys

If the grid is on, you can move the control(s) in steps of the grid. If the grid is off, you can move the con-

trol(s) in steps of one pixel.

 Aligning

Use the [Align Left] button / [Align Right] button / [Align To Top] button / [Align To Bottom] button / [Align

Horizontally] button / [Align Vertically] button / [Horizontal/Center Align] button / [Vertical/Center Align]

button in the tool palette to align multiple controls as desired. The [Align Horizontally] button and [Align

Vertically] button can be used only if three or more controls are selected.

1 2 ... 182 183 184 185 186 187 188 189 190 191 192 ... 210 211

Žádné komentáře

Yamaha Amp Editor Uživatelský manuál Strana 187