Yamaha F150 Servisní příručka stáhnout pdf (Strana 28)

GEN

INFO

General information

1-23

63P3F11

Checking the outboard motor

mounting height

1. Check that the anti-cavitation plate is

aligned with the bottom of the boat. If the

mounting height is too high, cavitation

will occur and propulsion will be reduced.

Also, the engine speed will increase

abnormally and cause the engine to

overheat. If the mounting height is too

low, water resistance will increase and

reduce engine efficiency.

NOTE:

The optimum mounting height is affected by

the combination of the boat and the outboard

motor. To determine the optimum mounting

height, test run the outboard motor at differ-

ent heights.

2. Check that the clamp brackets are

secured with the clamp bolts.

Checking the remote control cables

1. Set the remote control lever to the neu-

tral position and fully close the throttle

lever.

2. Check that the stopper

on the throttle

lever 2 contacts the fully closed stopper

on the cylinder block.

3. Check that the center of the set pin

aligned with the alignment mark

the bottom cowling.

CAUTION:

The shift/throttle cable joint must be

screwed in a minimum of 8.0 mm (0.31 in)

S63P1040

S63P3270

S69J3370

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 312 313

Žádné komentáře

Yamaha F150 Servisní příručka Strana 28