Yamaha F150 Servisní příručka stáhnout pdf (Strana 227)

63P3F11

7-18

1

2

3

4

5

6

7

8

9

Removing the clamp brackets

1. Remove the power trim and tilt unit. For

removal procedures, see “Removing the

power trim and tilt unit.”

2. Remove the anode.

3. Remove the bolt and grease nipples, and

then disconnect the ground leads.

4. Remove the self-locking nut and bolt.

5. Remove the through tube, then disas-

semble the clamp brackets, trim sensor

cam, and swivel bracket.

6. Remove the trim sensor.

7. Remove the tilt stop levers.

Installing the clamp brackets

1. Install the tilt stop levers onto the swivel

bracket assembly.

2. Install the trim sensor

1

and bushings

onto the swivel bracket assembly.

3. Assemble the clamp brackets, washers,

and swivel bracket, and then install the

through tube.

NOTE:

• Make sure that the trim sensor cam is

installed between the swivel bracket holes.

• Adjust the trim sensor cam after assembly.

4. Install the bolts on the through tube, and

then tighten the self-locking nut to the

specified torque.

5. Install the power trim and tilt unit, then

the anode.

NOTE:

Install the ground lead between the power

trim and tilt unit and the anode.

6. Install the ground lead between the

clamp brackets and the swivel bracket.

7. Apply water resistant grease through the

grease nipples.

NOTE:

Apply the grease until it comes out of the

bushing

a

.

Adjusting the trim sensor cam

1. Fully retract the power trim and tilt unit.

2. Loosen the trim sensor cam screw

1

.

3. Adjust the trim sensor cam

2

where the

specified trim sensor setting resistance is

obtained.

S60X7140

1

LT

271

T

R

.

.

Self-locking nut:

15 N·m (1.5 kgf·m, 11.1 ft·lb)

S63P7320

a

AA

AA

AA

Clamp brackets

1 2 ... 222 223 224 225 226 227 228 229 230 231 232 ... 312 313

Komentáře k této Příručce

Žádné komentáře