Yamaha disklavier Mark II XG Series Uživatelský manuál stáhnout pdf (Strana 12)

(D TO CONTROL CABLE FOR PIANO

The control cable from the piano is connected

here.

® MIDI IN

This connector provides access to the

Disklavier and internal XG tone generator. You

can connect a MIDI keyboai'd, synthesizer, or

MIDI sequencer to control the Disklavier,

internal XG tone generator, or both.

C5) MIDI OUT

This connector is used to output MIDI data

from the Control Unit. It allows output to

MIDI-compatible tone generators,

synthesizers, samplers, etc.

® OUTPUT R, L/MONO

These connectors are used to output audio

signal from the internal XG tone generator.

For Ensemble song playback, powered

speakers should be connected to these

terminals.

If your system is mono, use only the L/MONO

connector.

Mains Switch & Foot Controller

Foot Controller connector

Mains switch

® MAINS (ON/OFF) switch

This switch is used to switch the Disklavier on

and off. See pages 13 and 14 for information

on power ON and OFF procedures.

Note: The MAINS switch only needs to

be switched off when you are not

going to Li.se the Disklavier for a

long period of time. For daily use,

only the [STANDBY - ON] button

on the Control Unit needs to be

switched on and off.

@ FOOT CNTRL connector

An optional Yamaha FC-4 or FC-5 foot switch

can be connected here for starting and pausing

playback, and recording.

The optional Yamaha FC-7 foot controller pro

vides control over playback tempo, as well as

the above functions.

10 Chapter 2 : Names of Parts and Their Functions

Remote Control

©-

PART SELECT

L )) |( R

SEARCH

REV*FWD VOLUME

SONG SELECT

PAUSE STOP

®

YAMAHA

REMOTE CONTROL TRANSMITTER PPR-100

® [RECORD] button

Press to engage the Record Standby mode

before recording stalls.

@ Number keypad*

Used for direct song selection and to enter a

start time for song playback.

@ [REPEAT] button*

Used to select one of the Repeat functions:

ALL, RPT, or RND.

® [A-B] button*

Used to enter A and B points for Segments

A ~ B and A ~ Repeat modes.

® [REV FWD] buttons

In Play mode, these buttons work as fast

preview and review.

In Pause mode, they work as fast forwm-d and

reverse.

® [SONG SELECT] buttons

U.sed to select songs.

® [PLAY] button

U.sed to start playback.

® [PAUSE] button

U.sed to pau.se playback and recording.

® [STOP] button

U.sed to stop playback and recording.

® [PART SELECT] buttons

For L/R and Ensemble songs, these buttons

ai*e used to choose which part will play; left-

hand pail, right-hand pai1, or both parts. They

are also u.sed to .select a part for recording.

® [SEARCH] button*

Used to stai't playback from a specific time in

a song. Press this button, enter the stmt time

using the Number keypad, then press this

button again.

® [TRANSPOSE] buttons

Used to transpose song playback.

Press the [-] button to transpo.se down, the [+]

button to transpo.se up.

The [0] button is used to re.set the transposition

value to 00.

® [TEMPO] buttons

U.sed to change the playback tempo.

Press the [-] button to decrease the tempo, the

[+] button to increase the tempo.

The [0] button is u.sed to reset the tempo to 00.

® [VOLUME] buttons

Used to adjust the volume.

Press [-] button to decrease the volume, and the

[+] button to increa.se the volume.

* These buttons are available only on the remote

control.

Remote Control

11

1 2 ... 7 8 9 10 11 12 13 14

Komentáře k této Příručce

Žádné komentáře