Yamaha XLT1200 Uživatelský manuál stáhnout pdf

Engine Removal / Installation

Yamaha 1200 pv

Step 1

Battery Removal

1.1 (Above) Remove the two retaining

straps, disconnect the battery and remove it

from the hull. Disconnect the negative

(black) cable first, then the positive (red).

Step 2

Exhaust Removal

2.1 (Below) Pop open the three bolt

covers on the exhaust heat shield and

remove the three 10mm bolts.

2.2 (Below) Loosen the band clamps

around the stinger bypass water line and

through-hull exhaust coupling. Remove the

water line and using a 14mm wrench,

remove the water sensor.

2.3 (Below) Loosen the band clamps

securing the exhaust coupler jacket to the

pipe and slide it all the way forward to clear

the joint.

2.4 (Below) Loosen the rear band clamp

securing the pipes together. Remove the

four 12mm bolts and nuts securing the rear

pipe section to the block. Remove the rear

most bracket 12mm bolt securing the pipe

to the bracket (not pictured). Remove the

rear pipe section from the hull.

2.5 (Below) Remove the front exhaust

water line.

1 2 3 4 5 6 7 8 9 10

Yamaha 1200 pv 1
Engine Installation 7

Shrnutí obsahu

Strany 1 - Yamaha 1200 pv

Engine Removal / Installation Yamaha 1200 pv v 1.0 © 200

Strany 2

Strany 3

Strany 4

Strany 5

Strany 6

Strany 7 - Engine Installation

Strany 8

Strany 9

Engine Removal / Installation Yamaha 1200 pv v 1.0 © 200

Strany 10

Engine Removal / Installation Yamaha 1200 pv v 1.0 © 200

Komentáře k této Příručce

Žádné komentáře

Yamaha XLT1200 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Motor Yamaha XLT1200. Engine Removal / Installation Yamaha 1200 pv Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Motor Yamaha XLT1200