
CDR200tSERIESREAD/WRITEON/DISCRecordableVOL62READWRITEUser GuideGuide de I’utilisateurBedienungsanleitung
Chapter 1 - System Configuration 4 About Discs CD-R Discs On the CDR200t, you can use conventional CD-R discs that conform to the Recordable Compact
Chapter 2 - Installing the Yamaha CDR200t Drive 5 Chapter 2 - Installing the Yamaha CDR200t Drive CDR200t drive settings Before installing the CDR dr
Chapter 2 - Installing the Yamaha CDR200t Drive 6 ♦ SCSI ID settings The SCSI ID number is used so that the computer will recognize a connected SCSI
Chapter 2 - Installing the Yamaha CDR200t Drive 7 ♦ Parity setting Parity ON (with a jumper)— Parity Check will be performed. Normally, use this se
Chapter 2 - Installing the Yamaha CDR200t Drive 8 ♦ Block size setting Block size ON (with a jumper)— Block Size is set to 512Byte/sector. This func
Chapter 2 - Installing the Yamaha CDR200t Drive 9 Audio output cable Connect an audio output cable to the AUDIO OUT connector in the lower left corne
Chapter 3 - Operation10Chapter 3 - OperationFront Panel1 Disc trayThe disc is inserted and ejected here. Pressing the eject button will open the tray
Chapter 3 - Operation11Loading a Disc1. Press the eject button to open the tray.2. Carefully place the disc, label-side up, on the disc tray.3. Press
Chapter 3 - Operation12Ejecting the DiscIf the CDR200t is powered on:Press the eject button to eject the disc.Note: You cannot eject the disc if the S
Troubleshooting13TroubleshootingIf CDR200t is not performing as expected, look up the symptoms in the following table, then see what to do.Symptoms Wh
FCC INFORMATION (U.S.A.)1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!This product, when installed as indicated in the instructions contained in this m
Appendix14SpecificationsSpecifications are subject to change without prior notice.Interface SCSI 2Data Capacity 1.2m/sec: 666MB1.4m/sec: 540MBRecord/Rea
Appendix15Front Panel Indicator Key● on: green ✦ flashing: green — off❍ on: orange ✧ flashing: orangeStatus ON/DISC Read/WriteReset ——Ready (no disc)
YAMAHA CORPORATIONElectronic Systems DivisionVY75970-1
This output is value measured at a distance 200mm from the objective lens surface on the optical pick-up block.ANSI Class : Class 1Material : GaAlAsWa
WARNING i ❢ WARNING ❢ • The temperature where CDR200t is located should be between 5ºC and 40ºC (41ºF – 104ºF), when used in a fan-cooled system.•
Important Precautions ii Important Precautions Please read the following precautions before attempting to operate CDR200t.• Before recording a disc,
Table of Contents iii Table of Contents Introduction ... 1CDR200t Features
Introduction 1 Introduction Thank you for purchasing a Yamaha CDR200t drive. Please read this manual before using the drive in order to make the best
Introduction 2 Orange Book Compatible Recording Track at Once In this mode, data can be recorded to disc one track at a time. Discs recorded in this
Chapter 1 - System Configuration 3 Chapter 1 - System Configuration In order to use the CDR200t, you will require the following. For an IBM-PC compute
Komentáře k této Příručce