Yamaha CD S2000 - SACD Player Uživatelský manuál

ABPrinted in Malaysia ZG15720Integrated Amplifier© 2013 Yamaha CorporationOWNER’S MANUAL

10 EnControls and functions Rear panel1 TUNER input jacks2 GND (Ground) terminal3 PHONO input jacks4 CD input jacks5 BAL 1/BAL 2 (balanced) input jac

11 En9 PRE OUT jacksy• The PRE OUT jacks output the same channel signal as the SPEAKERS L/R CH terminals.• When you connect a stereo cable to the PRE

12 EnControls and functions Remote control1 Infrared signal transmitterOutputs infrared control signals.2 p AMP keyTurns this unit ON or switches it

13 En5 p CD keyTurns the Yamaha CD player ON or switches it to STANDBY mode.6 OPEN/CLOSE keyOpens/closes the disc tray of the Yamaha CD player. Refer

14 EnControls and functions Installing batteries in the remote control1 Remove the battery compartment cover.2 Insert the two batteries (AAA, R03, UM

ConnectionsIn this section, you will make connections between A-S3000, speakers, and source components.

16 EnConnections• Do not let the bare speaker wires touch each other or do not let them touch any metal part of this unit. This could damage this unit

17 En• Because the power amplifier of A-S3000 is of the floating balanced type, the following types of connections are not possible.– Connecting with

18 EnConnections Connecting the speakers1 Remove approximately 10 mm of insulation from the end of each speaker cable and twist the exposed wires of

19 En Bi-wire connectionThe bi-wire connection separates the woofer from the combined midrange and tweeter section. A bi-wire compatible speaker has

A Living Tradition in SoundA piano comes into this world through the perfect synergy of advanced technical skill and artistry. Such a piano can create

20 EnConnections Connecting to the BAL 1/BAL 2 jacksConnect your CD player or network player with the XLR balanced output jacks. Set the ATTENUATOR s

21 En Operating this unit from another roomIf you connect an infrared receiver and transmitter to the REMOTE IN/OUT jacks of this unit, you can opera

22 EnConnections Connecting a component supporting the trigger function such as a Yamaha AV receiverThe operations of this unit can be controlled in

SpecificationsIn this section, you will find technical specifications for A-S3000.

24 EnSpecificationsPOWER SECTION• Rated Output Power(8 Ω , 20 Hz to 20 kHz, 0.07% THD) ... 100 W + 100 W(4 Ω , 20 Hz to 20 kHz, 0.07%

25 En Block diagram BAL 2 CD TUNER LINE1 LINE2LINE2 OUT PHONO INPUT SELECTOR ATT.UINT1 PRE OUT MAIN INMM//MCFLOATING BALANCESPEAKER DRIVERMOSFETL CHF

26 EnSpecifications Tone control characteristics Total harmonic distortion10 20 30 50 100 200 300 500 1kFrequency (Hz)Response (dB)2k 3k 5k 10k 20k

27 En Total harmonic distortion (PHONO)100µ 200µ 500µ 1m 2m 5m 10m 20mGenerator Level (Vrms)50m 100m 200m 500m 1 220Hz 1kHz 20kHz1052310.50.20.30.020

28 EnTroubleshootingRefer to the chart below if this unit does not function properly. If the problem you are experiencing is not listed below or if th

29 EnProblem Cause RemedySee pageThe sound from the component connected to the BAL 1/BAL 2 jacks is degraded.The sound level is higher than the maximu

Excellence in Audio AchievementFirst HiFi System introduced in 1920We introduced numerous HiFi components (turntables, FM/AM tuners, integrated amplif

ABPrinted in Malaysia ZG15720-2Integrated Amplifier© 2013 Yamaha CorporationOWNER’S MANUAL00_Cov_A-S3000_AB.fm 2  

4 En◆ Full floating and balanced circuit design achieves the full potential of analogue amplificationAn entirely new floating and balanced power ampli

5 EnControls and functionsIn this chapter, you will learn the controls and functions of A-S3000.

6 EnControls and functions Front panel (pages 6 to 9)1 STANDBY/ON/OFF switch Turns on or off this unit.STANDBY/ON (upper position):In this position,

7 En5 SPEAKERS selectorTurns on or off the speaker set connected to the SPEAKERS L/R CH A and/or B terminals on the rear panel.• Switch to the OFF pos

8 EnControls and functions Front panel (pages 6 to 9)A Remote control sensorReceives signals from the remote control.yThe remote control transmits a

9 EnC PHONO switchSelects the type of magnetic cartridge of the turntable connected to the PHONO jacks on the rear panel.• Press upward to the MM posi